top of page

Model SLB Nitrogen Inerted Process Chambers

Our small, portable process chambers are convenient and easy to use. Place your coated product inside the chamber, expose to UV radiation, and see the benefits of nitrogen inerted UV curing immediately.

Available in several standard sizes, with a hinged lid for quick sample or product placement, and are used in process development labs and production settings.

  • UV conveyors - place on the in-feed of the conveyor and under the UV curing system

  • UV flood lamps - place under the UV flood lamp to achieve the required UV dosage

  • UV spot cure - expose through the quartz glass, can be used with a robotic XY table

  • UV exposure chambers - place in the chamber and expose

Model SLB-05-08H

IMG_4254.JPG
IMG_4251.JPG
The low height of .82" (20.8mm) fits the in-feed of most lab UV conveyors.

Loosen the (8) lid retaining screws using the provided hex wrench, and rotate the upper half back. Place the coated product in the chamber, drop the lid back and lightly tighten the captive screws.
  • Outside dimensions 133mm X 222mm X 20.8mm (5" X 8"X .82")  

  • Interior chamber size 167mm X 101mm X 14mm (4" X 6.5" X 1/2")

  • Quartz glass window transmits 90% of UV

  • Quick-disconnect for nitrogen supply with double check valves

  • Nitrogen distribution manifold ensures rapid and complete purging

  • Check valves allow air to escape, then trap nitrogen

  • Provided in hinged protective case with foam interior

  • See spec drawing for more details

K00520-01 Rev B.jpg

Model SLB-10-14

Undo the two quick release clamps, and lift lid until the prop swings into place.  Lower the lid slightly to engage the prop, then place the coated product in the chamber. Lift lid, push the prop out of the way, lower the lid, and latch.  Connect the nitrogen supply to the quick disconnect, and flush for about a minute.  Disconnect and run the SLB under the UV lamp.
  • Outside dimensions 10.16" X 15.06"X 1.38" (258mm X 383mm X 35mm)

  • Inside dimensions 9" X 12" X 1.10" (228.6mm X 304.8mm X 28mm)

    • ​Will fit 8 1/2" X 11" or A4 sheet of material​ (210mm X 297mm)
  • Quartz glass window transmits 90% of UV

  • Quick-disconnect for nitrogen supply with double check valves

  • Nitrogen distribution manifold ensures rapid and complete purging

  • Check valves allow air to escape, then trap nitrogen

  • Provided in protective plastic case with foam interior

  • See spec drawing for more details

K00506-01 Rev B.jpg
bottom of page